欧美久久综合性欧美,少女たちよ在线观看动漫游戏,天天做天天爱夜夜爽

Language: Chinese line English

News

Detailed introduction of tower crane wire rope

The diameter of the wire rope shall not be larger than 1/60~80 of the coil diameter.
The reason for the deviation of the drum wire rope of the tower crane hoist is: the tower cap wheel is not at a vertical angle of 90 degrees to the center of the drum, and the wire rope runs in the direction of the corner, that is, the angle less than 90° is close to the tower cap wheel, and cannot run far; Move the wire rope to the side of the deviation (left side) to the tail end of the balance arm, or move it to the right direction of the tower cap, both of which can be corrected by one-point at the same time.

The rotor wheel is the maximum inner diameter of the steel rope, and the camber angle cannot exceed 1°30°. When single winding, the internal declination should ensure that the rope does not bite. Some tower cap wheels use "pulleys", which are not enough to swing from side to side.
First of all, let's talk about the serious reasons why the roller bites the rope:
①The rope and the drum are seriously inclined and wound.
②: The wire rope path problem of the drum (the rotation degree is not high during production, and as a result, the rope is too tight and the rope bite phenomenon occurs)
③: The wire rope has less oil pollution!

Solution:
① Increase the fixed rope facilities. Rope row can only solve the slight rope bite phenomenon! Some equipment can only increase the guide rope and rope row device.
②Change the roll (this - the reason rarely happens)
③Regular maintenance (use good oil)
The luffing drum bites the rope in the following cases:
Please pay attention to check the angle between the drum and the arm root wheel. There is no vertical relationship between the hoisting arm and the drum (about 85°~87°). If there is a vertical angle, the curled rope will jump to the "rope path" and quickly enter the drum Therefore, the rope capacity of the reel is insufficient, and the wire rope "stomps up". The solution is to adjust the angle between the luffing mechanism and the arm root wheel.

CONTACT US

Contact: AULONE

Phone: 86-15573139663

Tel: 86-0731-83165008

Email: [email protected]

Add: Address:Kaiyuan road 36,Chunkou,Liuyang, Hunan,China. 

        

          

          
主站蜘蛛池模板：
揭东县|
千阳县|
灌云县|
渝中区|
临夏县|
会泽县|
革吉县|
革吉县|
乃东县|
寻乌县|
富川|
新郑市|
大宁县|
大理市|
锦屏县|
延安市|
江孜县|
万年县|
白山市|
柳江县|
建始县|
介休市|
六安市|
利辛县|
永嘉县|
阳信县|
赣州市|
阜平县|
安宁市|
瑞昌市|
肃北|
抚州市|
九台市|
米易县|
南涧|
达孜县|
淮南市|
伊金霍洛旗|
出国|
会泽县|
黔西|